Issue User is reciving a GUI pop-up messages that says the following, and asks for the root password at login: When logging into a VNC session as user the following message is received: Environment Red Hat Enterprise Linux 6 gnome-packagekit, several versions Resolution Solution 1: Ensure that the system is properly registered with RHN/Satellite (Re)register…
On system connected to printer In system-config-settings under server settings check Share published printers connected to this system. On system connecting to remote printer Using makePrinter, create a printer using the same printer name as server. Also, hostname of server must be in /etc/hosts. The UIR(port) should be ipp-1. Using system-config-printers, modify Device URI to read ipp//host-IP:631/printers/printer-name This allows for remote printing using the internet printer protocol.
Water Damage NMR had a failure with the air dryer system that caused water to enter the airlines of system all the way thru the shim coil. Had to replace the following: All system air solenoids Shim Coil Also had to clean the upper barrel for proper spinning. Shim Coil was replaced with an Oxford…
De-Energize and Pack De-energized and packed system for shipment to Canada. System was de-energized and warmed up and then packed into Oxford shipping crate (including sides). Four pieces were shipped to IET for final crating and packing. Customer arranged for pickup by a freight carrier. Found the following issued during benchmark; Remote Status box inop…
nstalled DOTY HX probe. Lineshape was marginal, as was S/N. Had to install sample from below like a solids probe. Was unable to get it to work with the upper barrel and sample eject because the probe is longer and has too much air leakage. See message below sent to DOTY. Judy, I was assisting…
Repaired various issues with the DD2 400, and Mercury 400. Also, had to figure out how to setup Mercury for Q-Tune because it has a protune accessory. Mercury also had a bad High Band transmitter that had several steps from its attenuator bad.
De-Energize Varian Magnex 600 Magnet De-Energized magnet using three supplies set as follows: Supply 1 – Main Supply 2 – RPS / Z0 Supply 3 – Z2 Supply 1 and 2 applied thru the 10-way connector on the neck tube. Supply 3 applied thru the shim stick. Main heater would not open when it was…
Mercury 400 Alarm Found that the PS204, which is a +12VDC and +5VDC power supply had a capacitor that was bulging. Tested the +12VDC and observed the following: When OK 12.4 VDC 0.1 VAC When Beeping 11.8 VDC 0.8 VAC At Startup 10.5 VDC 1.5V AC Ordered replacement power supply from Mouser Electronics. Part Number: HCC512-A+G…