Completed Install of SMS Robot and SYS-V Controller. Customer had table, cables and interface cards.
| Vertical | Reach | Rotation | |
| CP1:AT.HAND.GP | 1.8 | 30.3 | 89.9 |
| CP1:CLEAR.HAND.GP | 24.8 | 0.0 | 89.9 |
| HAND.GP | 16.2 | 19.9 | 89.8 |
| CP31:RACK P1 | 19.5 | 4.7 | 76.3 |
| CP31:RACK P2 | 19.5 | 4.6 | 43.2 |
| CP31:RACK P3 | 19.5 | 27.2 | 49.3 |
| CP191:MAGNET | 19.3 | 21.9 | 272.0 |
| CP191:CLEAR | 34.0 | 0.0 | 272.0 |
Filled three NMR magnets using 100L dewer (filled with only 70L). Magnet Start End Total Oxford 500 34% 100% 66% 72L 40L 32L 10:10 10:35 25 mins Oxford 300 Unknown 100% NA 40L 25L 15L 10:45 10:55 10 mins Bruker 500 80% 100% 20% 25L 0L 25L 11:00 11:15 15 mins
SMS alignment off by about 1/2 cm causing sample move failure. Re-aligned SMS. Ve Re Rt CP1:AT.HAND.GP 2.0 30.4 90.0 CP1:CLEAR.HAND.GP 23.0 0.0 90.0 HAND.GP 16.5 19.9 90.1 CP31:RACK P1 19.5 4.7 76.6 CP31:RACK P2 19.5 4.7 43.7 CP31:RACK P3 19.5 27.2 49.7 CP191:MAGNET 13.4 29.6 259.3 CP191:CLEAR 34.0 0.0 259.3
Customer reported that they could not lock (using 2H) or gradient shim. Looked at 2H RF path and good signal coming out of console to probe. Problem must be on receive side. Swapped the following parts for troubleshooting: 2H Diplexer Lock Preamp 2H RF Relay (verified operation) 2H Filter (bypassed) Believe issue is the Mixer…
Filled three NMR magnets using 100L dewer. Magnet Start End Total Oxford 500 28% 100% 72% 95L 45L 50L 8:20 8:40 20 mins Oxford 300 Unknown 100% NA 45L 10L 35L 8:50 9:05 15 mins Bruker 500 81% 91% 10% 10L 0L 10L 9:15 9:20 5 mins
Repaired various issues with the DD2 400, and Mercury 400. Also, had to figure out how to setup Mercury for Q-Tune because it has a protune accessory. Mercury also had a bad High Band transmitter that had several steps from its attenuator bad.
Checked Advance III HD RF output on H1. At PLW1 of 100 dBm Watts SGU2 Out 1.33 dBm 1.4 mw BLA Out 51.78 dBm 150.6 w QNP Out 51.33 dBm 135.8 w HPPR In 49.48 dBm 88.7 w Probe In 49.24 dBm 83.9 w PLW1 at BLA Out dBm Watts 10 41.75 dBm 14.9 w…